1. Wake the screen

Tap the button once to show the time.

2. Enter Time Set mode

From the time screen, press & hold the button for ~3 seconds. The hour will start flashing.

3. Set the hour

Tap the button to increase the hour (each tap = +1).

4. Set the minutes

Press & hold ~3 seconds again to switch to minutes (minutes flash). Tap to increase minutes.

5. Save & exit

Stop pressing buttons and wait ~8 seconds. It will save and return to the normal time screen.

1. Go to Alarm 1 screen

From the time screen, tap the button 5 times until you see Alarm 1. If it shows "OF", that alarm is OFF.

2. Turn Alarm 1 ON + set time

Press & hold ~3 seconds to start setting Alarm 1. The hour will flash. Tap to adjust the hour.

3. Set minutes

Press & hold ~3 seconds to switch to minutes (minutes flash). Tap to adjust minutes.

4. Save & exit

Stop pressing buttons and wait ~8 seconds to save.

1. Go to Alarm 2 screen

From the time screen, tap the button 6 times until you see Alarm 2. "OF" = OFF.

2. Turn Alarm 2 ON + set time

Press & hold ~3 seconds to set it. Tap to set hour → hold ~3 seconds → tap to set minutes.

3. Save & exit

Wait ~8 seconds to save.

Navigate to the alarm screen

Go to the alarm screen (Alarm 1 = 5 taps, Alarm 2 = 6 taps). Set it to "OF" (OFF).

Locate the USB connector

Find the built-in USB charging connector on the end of the band.

Plug into a low-power USB source

Use a laptop USB port, desktop computer USB port, or a standard low-output USB hub (5V). Insert the band straight and level into the port.

Charge fully before first use

Allow the band to charge completely before using it for the first time. A full charge lasts up to 14 days.